ENAG 6RICSKRH007A Power Supply Card

ENAG 6RICSKRH007A Power Supply Card for Maritime Hydraulic 5T-113D

The ENAG 6RICSKRH007A Power Supply Card is an important electrical component designed for the special needs of the Maritime Hydraulic 5T-113D crane series. Offshore operations are a brutal environment, where consistent voltage regulation is not just preferred but required for safety. This power supply card is the heart of the crane control logic, transforming the main shipboard power into the stabilized DC voltages needed by sensitive sensors, limit switches, and hydraulic solenoid valves.

The 6RICSKRH007A is designed by ENAG, a leader in marine power conversion, to survive the extreme vibration, salt-mist and varying thermal conditions that are typical in engine rooms and deck machinery housings. This authentic MPN replacement of a defective card will keep your crane’s 5-ton lift certification in place without the danger of control system latency or catastrophic failure.

Technical Details

Guide from Our Engineer:

When the 5T-113D crane exhibits ghost faults—such as intermittent limit switch failures or sluggish solenoid response—the 6RICSKRH007A card is the first place I look. Often, the ship’s primary power fluctuates when heavy winches engage, and if this card’s filtering capacitors are worn, those fluctuations pass directly into your control logic.

1. The Clean Power Check
   Before installing your new ENAG card, check the input terminals for carbon tracking. If the previous card fried, there may be a short in the wiring loom that will immediately damage the new component.
2. Heat Dissipation
   Ensure the standoffs are secure. Marine cranes vibrate significantly; a loose mounting will not only cause mechanical stress but can interfere with the card’s ability to dissipate heat through its ground plane. Always use a dab of non-conductive thread locker on the mounting screws.